 |
||||||
|
|
||||||
| Batten | Link Channel | Clip | ||||
|
|
 |
|
||||
| Nu-lok
steel battens replace traditional wooden battens that tend to
rot, twist and warp. Each Nu-lok batten is cold rolled from hot dipped galvanised steel. |
Nu-lok Link Channels are made under ISO 9001 standards using a metal coil made to EN 10147. They are designed to channel moisture passing through the gap between the Ceramic or natural slates onto the shingle below, so the moisture can run off down the roof into the gutter. | Each
Nu-lok 316 stainless steel Clip is produced under ISO 9001 standards. The Clips are available in two different wire diameters, 1.6 mm and 2mm. The thicker wire for more extreme service conditions. |
||||
|
- Site Delivery Detail - |
||||||
| Bundles of 9 battens are secured by plastic reinforced straps and weigh 25 Kgs per bundle (2.8 Kgs per section of batten). | Link Channels are delivered to site in boxes of 84 per box along with 84 stainless steel clips per box. | Clips packed in bundles of 42 per bag. Delivered to site in boxes along with Link Channels. Two bags of 42 clips per box. | ||||
|
- Detail Properties - |
||||||
| Length
=4.2 metres Gauge=1.2 mm Battens /squ. metre = 3.67 lineal metres Material = galvanised steel produced to DX51D + Z275 BS EN 10142:2000 |
Gauge = 0.8 mm Material=galvanised steel Link Channels/squ. metre=8.33 Finish = black E-cote |
Gauge=
1.6 & 2.0 mm Clips/squ.metre=8.33 Finish=black Material= stainless steel 316 produced to BS 2056 1991, 316S42 |
||||
|
Nu-lok gains British Board of Agrément approval  The certification of the Nu-lok system is available in detail in the following document :- Download here (176 KB) The Irish Agrément Board is designated by Government to issue European Technical Approvals. The IAB, Irish Agrément Board is part of the NSAI, National Standards Authority of Ireland. The certification of the Nu-lok system is available in detail in the following document :- IAB-Nu-lok Roofing System (pdf file 572KB) |
||||||
